Data sheet

HSS-G countersink 90°, DIN 335, 2,5 - 10,4 mm
Item number:
BOHR KS 10,4 HSS
Example illustration
Item description
Description:
3 cut, right cutting countersink, form C 90°, radial undercut, for burr-free and zero chatter counter sinking, deburring and sinking. Best results with low cutting speed, good centring, good centring and chip removal. For countersinking according to DIN 74 and DIN 75.
Qualities:
HSS-G:
Use for steel, cast steel alloyed and unalloyed (<900 N/mm² tensile strength), grey, malleable, nodular and die cast iron, sintered iron, nickel silver, graphite, short-chipping aluminium alloys, brass, bronze and plastics.
HSS-G Co 5 (HSS-E):
Use for steel, cast steel alloyed and unalloyed (<1100 N/mm² tensile strength), grey, malleable, nodular and die cast iron, sintered iron, nickel silver, graphite, short-chipping aluminium alloys, brass, bronze and plastics. Can also be used for hot and cold work steels, as well as rust and acid resistant steels (stainless steels V2A / V4A).
Properties
Qual­ity HSS-G
Ver­sion sin­gle coun­ter­sink
Coun­ter­sink di­am­e­ter [mm] 10,4
Tip di­am­e­ter [mm] 2,5
Total length [mm] 50
Shaft di­am­e­ter [mm] 6
for screws M 5
Further information:
Weight 21 g / pcs
GTIN 4050571159641
Customs duty number 82079091
Manufacturer RUKO
More information on this item and the process for ordering it can be found in our online shop https://www.landefeld.de under item number BOHR KS 10,4 HSS.
Landefeld Druckluft und Hydraulik GmbH · Konrad-Zuse-Straße 1 · 34123 Kassel · Germany
All data are to be understood as non-binding reference values! We do not assume liability for any data selection not confirmed in writing. Unless otherwise specified, pressure values refer to liquids from Group II at +20°C.
As of: 02.04.2025